CAMO C345002 Marksman Pro X-1 Wide Board Tool

Great product and design.

I used this for the boards on my 50 square meter decking. Great fixing system, almost invisible when in place yet you can still get an individual board up if you need to.There's a couple of little tricks you learn and it's a good idea to watch and understand the Camo "how to" videos on YouTube. Especially the one about starting off the first row of boards by a wall.You do need to use their own brand screws because they're the other part of the system. So long as you understand this tool is just one half of the fixing system then you shouldn't have a problem with that.

This was used to install a large decking area and although slightly more fiddly than simple face fixing, the end result is fantastic, especially on smooth decking. It leaves no splinters on the face of the board or sunken troughs for water to sit and work its way past whatever oil/stain you treat the boards with.This was used with very green fresh pressure treated boards, so the 1.5mm gap setting of this tool is just right and I would not advise using any extra spacing. After drying out the gap between boards has now settled at somewhere near 5-6mm.

Being a professional carpenter of 15 years plus i was sceptical of this tool. I actually would have rathered to screw the board through the top. Stainless steel Counter sunk screws on a flat hardwood deck look great when done correctly and are in dead straight lines. My wife wanted concealed so i bought this. Now im fussy esp when i do stuff on my palace so i gave a few trial runs on some hardwood decking off cuts to get a feel. what i noticed are the small divits that where left on the adjacent board after screwing and at times the pre-drill holes on the corner of the board thus rendering the fixings not truly concealed. the gap is only 1.5ish mm so pretty small but ok for site seasoned hardwood. I was not happy with the divits etc so i superglued .9mm piece of small aluminium on the INSIDE of the tool spacing thus increasing the spacing to 2.4ish mm. this reduced the divits and moved the pre drill slightly away from the edge and further down the side of the board thus hiding the hole more effectively. i still got the odd mark which i could live with and visiters could not see anything. overall it best to have a little practice and see what works best for you. defo predrill on hardwood to prevent splitting. on butt joins i predrilled and plugged as splitting will occurs on board ends. i will be using this on next contracting job and overall you can achieve some good results when you tweak it here and there. just be sure to predrill ye hardwood

Good product that drives screw in to decking at an angle therefore orevenmtijg unsightly screw heads

Great piece of kit - takes effort to use and especially with hardwood as need to pre-drill but the outcome is well worth it

Well made, solid piece. Taken some abuse while making the decking and it still feels as new as day 1.