Southwire9044SW8808 Range Power Cord; 4-Foot; 1/4-Inch Flanged Terminals; Flat Plug; Compatible With Most Standard Free Standing Electrical Ranges With A 4 Conductor Wall Outlet; 125/250-Volt; 50-Amp

I clipped the ends off and used it fine with a Tesla Wall Connector. Be sure to twist the strands well before putting them in the terminals - they're finer than the kind of wire you'd hardwire with, so they'll tend to fan out under the screw and slip out to the sides. Otherwise, follow Tesla's instructions, including looping the cable and securing it with a zip tie. Be sure to use a 3/4 cable gland for strain relief and SET YOUR CHARGER TO 40 AMPS MAX! This cable is rated 50 amps, but for continuous loads like charging a car, code requires an 80% derate for safety due to heat build up... the default setting on Tesla chargers is 48 amps. Adding a 14-50 whip to a hardwired charger isn't code compliant anyway, but you'd be a fool not to abide by the 80% rule.

I was looking to convert a hardwired Juicebox EV charger to a plug-in charger with a NEMA 14-50 plug. This product fit my needs perfectly. The two hot conductors are 6 awg and capable of carrying 50 amps. The plug is sturdy and fits easily into the 14-50 receptacle. My EV charger reconfiguration project was a success.

Your can use this to install a Tesla Wall charger without having to hard wire it directly. Plenty of YouTube videos to document the steps. I've had this installed for over 6 months without issue. BUT you MUST lower your amps to 40a . Don't charge on max or you'll burn it out after a few months.

Uses #6 copper wire. 3#6 conductors and ground appears to be #8.

Worked well to install on my new range, and the 4' length was perfect - not too much slack to bind up under the appliance. My one suggestion would be to strip a bit more of the black outer insulation off since for ranges with 4 terminals you need a bit more flex to bend the 4 conductors (especially the ground) to fit the 3 main terminals and the chassis ground.

I think this is a very high quality item. I have had many of the competing brands. I have found this to be Superior and durability and the I thought that was put into the way it was made. It seems that detail was paid even to the smallest of items in it's creation and production. Anyone who has put in a large number of these will be able to pick out many features that this has that it's competition Lacks.

Bought this pigtail for my blink hq100 charger. Worked fine, but the length of wire after the cladding was an inch too long and I had to do some bending to make it all fit. Also the ends are a little too wide, so I had to crimp them down a little. Sorta pain. Also you’ll want to pick up a 1” romex connector since a spare doesn’t come with this it the blink charging station. You’ll also find that the charger doesn’t have separate ground and neutral leads, so you’ll have to tie them together since this is 4-wire. Maybe rethink what plug and receptacle you want if you only really need 3 wire!

I used this to convert my free hard wired Tesla Wall Connector to a plug in EVSE into a NEMA 14-50R reciprocal. I used a 3/4 cable gland for strain relief and SET THE TESLA WALL CONNECTOR TO 40 AMPS MAX! Be aware that a 14-50 whip to a hardwired charger may not be code compliant.