Car Styling Hood Bonnet Stripes Sticker Trunk Rear Engine Cover Vinyl Decal Stickers for Mini Cooper R56 R57 F55 F56 Accessories (Black-White)

Great

Works really well with little to no bubbles if you follow their application video. Use the water. It makes all the difference.

Easy application looks good

The stripes came rolled up tightly. This would’ve been okay, but the protective film was not flexible enough and was coming off and causing the edges to crease when I unrolled it. It was next to impossible to smooth it out. Then I noticed as I was removing the backing, that the silver edging on the black stripe was a separate piece, and it began peeling away. Another minor issue was that it needed to be trimmed to size. A microfiber cloth and squeegee were included, which was nice. There were no instructions provided, but there are plenty of helpful youtube videos out there. I was not able to successfully apply the stripes.

Overall the product is good, but if you want perfection you will be disappointed the first time you try this. The stripes were a little long, but cut down to size fine. The vinyl is thin. This means it stretches over curves easy, but is likely to bubble. Here are a few tips.1. When you get it, it was rolled up, and the top clear layer was bubbled up. Lay it out flat on a table and run a warm iron over it to flatten it out.2. Clean the surface of the car at least twice, then do it again before you apply. Dust is your enemy.3. Make sure the car is in the sun for a bit to warm up.4. Lay down painters masking tape on the outside edge as a guide. Measure from the center to make sure the stripes will go down symmetrically.4. Mist the hood with water. Easier to get the water even than misting the vinyl5. Once you place the strip, gently squeeze the bubbles out. Don’t press hard as the glue will stick down and trap bubbles. Also you can scratch the surface of the vinyl.That’s all. I will try it again and give an update

They look great. This is a two person job though.

If you’re buying this, you probably don’t do decals often. You will need sufficient experience to make this look right. It is packaged rolled up tightly. Buy two, you’ll probably screw one up.

I lacked the skill to apply these without getting things stuck under the film. The seller was really great about communication though. If in doubt, try it out.