LINKITOM New Submersible LED Trailer Light Kit, Super Bright Brake Stop Turn Tail License Lights for Camper Truck RV Boat Snowmobile Over 80" Inches

I rewired my boat trailer with these LEDs and it looks AWESOME! Not to hard to install and looks and works fantastic!! I would highly recommend!

Easy install, great lighting

Fit my pontoon trailer very well. Lights have 2 positions to mount them. Good idea! Only reason for 4 stars is the wires were not long enough for my 20' trailer. Had to splice about 3' on to the end.

great light kit bright lights reflectors and reflective tape with new wire and wire clips to attach to frame

Installed with ease. Bright and clear. Installed with water proof connectors. Recommend and good value.

The kit comes with pretty much everything you could ask for. Looks like decent quality stuff. Time will tell if these lights will continue to work after a few submersions, but for now they resolved my burnt out light issue and look good. Well packaged and very complete.

Lo compre para el tráiler de mi bote. 100% satisfecho con lo recibido.

Bought this to replace/upgrade the “bulb” lights on my boat trailer that were working fine – 4.4 stars with 2,334 ratings they had to be good. I figured it would be easier to do with the boat off the trailer so I launched the boat for my boys at 1:00 PM and when home to get working. I was tempted to use the existing wiring, but decided to replace it with the wiring provided. Directions were clear and followed exactly. I ran the new wires and got everything connected in about 1 hour. The hardest part was gathering up to tools. Before shrinking the waterproof connectors and covering them with shrink tubing, I had my wife start the Rav4 to see if the lights worked. Brakes, turn signals, brakes and turn signals together – all worked. Turned on running lights and they worked although they seemed to be “small” in the rear. Now to the issue, the brakes and turn signals did not work with the running lights on and I figured it was a bad ground. I redid the ground wire coming out of the harness and actually ran a second ground using self-tapping screw directly into the trailer – still didn’t work. I the tested each ground separately by disconnecting and reconnecting and all were fine which I expected since brakes/directional and running lights worked separately, but not together. NOTE: The Rav4 is an Adventure series that can tow 3500 lbs and came with Toyota installed towing package so there is enough power to run trailer lights (and the bulb lights worked fine). However, just in case I hooked he trailer up to my truck with pin converter (with test lights showing it was getting power/blinking ) – still the same issue. It was nearly 5:00 PM and I went back through everything to check if I made a mistake – nope. I searched the internet and Amazon and found an interesting review about the wire being cooper and a pigtail issue. My boys called and wanted to get picked up so I heat shrank all the connectors before leaving. After loading the boat, the running lights no longer worked when the running light were turned on, but the brake and turn signals worked which is exactly opposite if the prior issue. The next morning I hooked up my other boat trailer, utility trailer, and snow mobile trailer – all lights worked fine. I am putting the bulb lights back on.

producto recibidio es lo esperado graicas