Dorman 42058 PCV Valve Grommet - 0.428 In. ID - 0.983 In. OD - 0.610 In. Thickness Compatible with Select Lexus / Toyota Models

Fits a 2000 Toyota Camry with no issues, put a little motor oil on it helps fitting. I only had it installed for about 2 months, I’m not sure how long it will last. Build quality seems decent for the price.

Worked perfectly for my application. PCV Grommet for 2JZ-GE engine. On valve cover.

FIT MY 2000 TOYOTA TACOMA PRERUNNER, 2.7L BASE CAB, TIGHT FIT EVEN WITH GREASE, USED SAND PAPER TO ENLARGE IT TO FIT WITHOUT TEARING IN HALF.

Just what I needed

Got a new PCV valve and the OEM grommet ripped as I was trying to remove the old valve. Installed this new grommet along with new PCV valve. Good as new

I ordered this grommet for a '98 tacoma 4WD 3.4L V6 5VZ-FE. Despite seeing the other bad reviews, I figured I'd give it a try, assuming that the problems people were reporting were due to user error or just bad luck.However, as others have stated, these are terrible grommets. First of all, the inner diameter of these grommets is far too small when compared to the OEM grommet. So, you'll need to apply a lot of force in order to try to get the PCV valve into it. At this point, the grommet will most likely tear & break, as the rubber is brittle & of very cheap quality. I lubricated the grommet & tried my best to not overdo it when trying to install the PCV valve, but it still ended up tearing.I'm convinced that these grommets are either from very old stock that were stored improperly, or from a defective batch, and that they're being sold for cheap here on amazon in the hopes that most people won't go through the troubing of trying to return them based on the low price. It's either this, or Dorman has simply screwed up in their design and/or their 'application designation' for these grommets, because these clearly won't work for all of the Toyota models that they are claiming.I ended up returning this grommet & buying the OEM grommet directly from Toyota, which wasn't much more in price than this one. Save your time & money and avoid these. Buy another brand or OEM.

Good replacement for old loosened or cracked grommet on 2001 Tundra 4.7 on drivers side front valve cover. Be careful removing old one may crack and pieces may fall inside valve cover. Use some good needle nose pliers bend inward and pull out. May come out in pieces. Also using a headlamp for direct visualization is helpful and you can see if pieces fell in valve cover. Once new one is in it will fit valve cover and pcv valve perfectly. Do not think is worth money to buy Toyota brand grommet This is very inexpensive and worked fine. The pcv valve itself can just be cleaned with carburetor cleaner and reused. Unless you want to buy a new one - just because. The hose was starting to crack on both ends. Trimmed off 3/4 inch on each end but then was a little too short - still worked but decided to replace while was there and was now too short. 1/2 inch trim on each would have worked.

Repuesto funcional.