Ewigkeit 12V 40W Cartridge Heater 620 Ceramic and NTC Thermistor 100K 3950 for 3D Printer(Pack of 10pcs)

Good alternatives to the expensive brand. It has been working well since I start to use. No complains at all. Item arrived very fast and is exactly as described. Thermistor is very easy to hookup, and looks very high end material.

Used this to replace the heater cartridge and thermistor on my Anycubic Mega Zero. The wiring included is long enough to go all the way to the board, eliminating two connectors between the parts and the board. This thermistor does not have a connector on the end, as pictured, so I just soldered on my old connector that goes to the board. The heater cartridge does not use a connector.

Worked well at a low price! the original heater that came with my Anet A8 died after 2 months of use. So far the replacement I put in from this set has been going strong for 2 months and no issues.

Good product. Nothing to complain about.I ordered to install on a 3D printer. But the 3D printer had the thermistor inside a little cartridge but I have not found the cartridge assembly. But managed to solve the issue. And this one only have a temperature difference to other temperature sensors about .3°C.My main concern when I bought was to have a huge temperature difference or poor build quality. But surprisingly it is well built specially because I paid 9U$ for 5 and others online was close to 10 each!

my temp wires where starting to get a little wackey and I noticed the quality of my prints where going down. I replaced these and recalibrated my bed real good on my anet a8 and WOW WHAT A DIFFERENCE. I don't know if it was sending biased signals to the computer making the extruder miss heat and cool. but wow whatever it was changing these fixed it.

This is my second order because the first was wrong as well. 2 out of 2 packages are the wrong item so I guess someone wasn't paying attention when packing or labeling these. I knew something was wrong when the hotend only got up to about 125c and when I removed the cartridge and examined it I saw it was 24v. My printer uses 12v so these won't work.

I guess I was under the assumption that they came with end connectors. Splicing them on to my old heaters cord isn't too hard but 1 it's a pain and 2 it's certainly not professional or desirable. Just another point that can break so if I have to get a heating element again I certainly will not get this one.

I used the heaters to make a crayon melting spin-art device, and it works great. I have 4 extra heaters that I'll use for something else.

Super

Used a thermistor immediately and it works well. Make sure you buy the correct voltage. These are 12 CFC not 24 volts that some printers use.

Works so far, although it should be clearer in the title that it comes with 5 heating elements, not 10. The other 5 pieces are the thermocouples. Comes with lots of wire length.

Côté durabilité je ne sais pas mais le capteur de chaleur fonctionne et le bout chauffant aussi

Bad product no quality, broke af te et 8 hours loi f printing