Telescoping Trailer Stabilizer Jacks 2 Pcs, 11.8"-17.7" Folding Trailer Stabilizer Stands, Supports up 1000lbs Each, 11.8" Long Bar/Crack Included

These jacks are just with the doctor ordered for our pop! They’re easy to install and very sturdy!

We rebuilt an old camper. Took the dinette slide out, rebuilt the slide and the wall. This slide has a flat floor with a single center rail that the slide moves in and out on. It was a little bouncy getting in and out of the bench seats at the dinette. These solved the problem. The slide seems very stable now. These are sturdy, easy to use, and come apart easily to store. They are heavy duty with sharp edges, so beware of pinching skin and you take them apart and put them back together.

I purchased two sets to help take some snow load strain off my slide-in's camper jacks during winter storage. The jacks use crank lever bars that go through the screw and are used for rising or lowering the screw part of the jack. The ball ball bearing lock is missing on one of the crank lever bars. I only need a replacement for the one bar and don't need to go through the return and refund process. I have looked for the contact information for both the seller and the manufacturer but am not having any success in finding anyone to talk to about this problem. Also one of the cables was cut poorly and had some jagged wires sticking out which punctured my skin. Otherwise the jacks look to be good for the purposes intended.

These stabilizers have completely eliminated any sway or bounce in our slide out.

Product extends from 20” to 42”. The design is very simple and the extending to desired height is simple but tightening once extended is difficult. The pad turns as you attempt to tighten it. The pad should not be attached to the screw mechanism in a manner that does not allow it to be stationary while you turn the extension to tighten. I was unable to tighten to the point I did not have to “retighten” several times on a two week stay. Product is well made and strong but the above distracts from it being easy to use.

Buen producto y fuerte.

So I recently purchased a small trailer 4x8...and these help by installing them in the back to prevent the trailer from tipping over...but I am very worried the foot plate might come off since it only has 2 tac welds on each. These were replacements because the 1st set feet had broken off the welds. Might have to get a welder to secure it better...but I shouldn't have to

Good product, very strong. Would have like it were you could turn it too make it go higher without the pods moving while trying to adjust to a higher height