Gates K060882 Micro-V Serpentine Drive Belt

Perfect fit, quality and price

Used this on my 2001 Ranger 3.0. Solid quality and good, snug fit. Have used Gates hoses, water pumps, etc in the past on this and other vehicles with good results. Gates makes good aftermarket parts, would recommend this belt.

Head ache over

Replaced squealing belt. No more embarrassing squealing belt. Great price. Cheaper than localParts house.

I bought it bc it said it would fit my TJ Wrangler but it didn't. 4 stars bc it's good quality.

Perfect fit...great quality

I had to do a coolant system refurb on my Jeep WJ 4.0. The main problem was a worn out fan clutch but it was leaking around the water pump too.I did the "while you're in there's" too so water pump, fan clutch, thermostat, thermostat housing, heater hose pipe and Fel-Pro upgraded gaskets with Honda-Bond RTV Silicone sealant and a new serpentine belt too.Everything worked great but to get the old fan clutch off I had to cut the nut part that screws on to the water pump shaft. I used a new Milwaukee M18 Orbital Super Sawzall, my reward for doing this DIY job.I didn't want to buy the Sawzall but after trying two parts store rental fan clutch removal tools with absolutely zero success, I got medieval on it. 15 minutes and two saw blades later the repair could proceed.The lower fan shroud fasteners are another pain in the ass for that job but after that, no big deal.After carefully cleaning all of the gasket surfaces and applying a reasonable amount of Hondabond, everything reassembled easily, I put the old hoses back in place refilled the system and burped it.Now my engine temperature stays right at 195 I think and beside warming up, the needle never budges.Before it would overheat if I wasn't traveling at 45mph+ and I had to add coolant almost every time I drove. That was mostly the fan clutch causing that but everything I used to fix it is working perfectly so far.

Good quality belt and no speaks!